Search results

Search the forum Search WordPress Search MediaWiki
  1. W

    Replace a TCell 15 with a TCell 3?

    TCell 15 replacement UPDATE It's now been 2 years since I replaced my TCell 15 with a refurbished cell I found on Ebay - http://www.ebay.com/itm/Goldline-Haywar ... _500wt_922. So far results have been very, very good. Refurbished TCell 15 is performing as advertised with zero problems...
  2. W

    Replace a TCell 15 with a TCell 3?

    Poolschoolgrad, Thank you for your response and I had contacted GoldLine tech support and they stated the same as your response. They did off a similar solution by removing a "Jumper Switch" connection on the control board that will make it compatible with a TCell 5 (up 20k gallons). Found...
  3. W

    Replace a TCell 15 with a TCell 3?

    Need your expertise... Currently have a 9800 gallon in-ground pool installed July '04 with Aqua Rite Electronic Chlorine Generator and a TCell 15 Looks like I have squeezed all the chlorine generation I can with my current TCell 15 and it's time for a replacement - Current Diagonstic Displays...
  4. W

    Need your recommendation for on-line purchase of pump motor.

    Sorry for the minimal info... Looking for: - 3/4 hp - 3450 rpm - Currently have AO Smith, Cat: B625 - To replace Polaris - Horizontal booster pump
  5. W

    Need your recommendation for on-line purchase of pump motor.

    Need to replace the motor that powers my pool sweep pump. I replaced the same motor exactly 2 years ago and need your on-line recommendation where to purchase a replacement motor. Since I have a salt-water pool, fairly harsh environment surrounding the equipment and have quite a bit of...
  6. W

    Aqua Rite "No Flow"

    UPDATE- Ordered new Flow Sensor on Monday, arrived on Thursday = S U C E S S. :-D After pulling the old Flow Sensor, the grey wire was nicked which caused the NO FLOW indicator light to glow. Looks like I will try to sell the old flow sensor on Ebay to someone that can splice... Thanks to...
  7. W

    Aqua Rite "No Flow"

    Ordered new flow sensor today from: Harwil Corporation (Oxnard, CA) website = http://harwil.com/ Phone = 805-988-6800 Part Number = Q-12DS-C2 (Description = Goldline-2/No Tee) Price = $68.45(without Tee) + $13.00 UPS Ground shipping Will update you with results upon new install. Thanks to...
  8. W

    Aqua Rite "No Flow"

    By the way, the serial number of the cell begins with 5 and is going on 6 years old, small pool (10k gal.), keep after the chemistry and test weekly(ish) from April to October, located in Plano (Dallas) Texas. I'm leaning towards bad cell. Your thoughts?
  9. W

    Aqua Rite "No Flow"

    Checked the wire and RJ11 jack connection to the flow sensor and condition is good. Cell voltage readout = 30.9 and Cell current = 0...indicating, per your comment, that cell has shut down. Have not removed the Flow Sensor yet...is the sensor the entire brass fitting? Or a part that...
  10. W

    Aqua Rite "No Flow"

    Is the flow sensor located on the cell?
  11. W

    Aqua Rite "No Flow"

    Cant say enough about how great this swg system is . . . but . . . Have a glowing "No Flow" indicator lite for my AQUARITE T-CELL-15 40K cell. Went through all of the self-diagnosis steps (acid wash, water blast/rinse) and appears to be a bad cell. Question - what is the usual life span of...
Top Bottom
Back