Search results

I tried re-soldering and felt like it definitely improved the look of the solder joints. Tested the d1 diode and that was fine. Plugged it in and no luck. Any other suggestions other than to just buy a new one? Suggestions on where to buy just the board or do you have to buy the whole assembly?

Thank you, I had success re-soldering the main control boars a few weeks ago so I will try it out. Any reason why the red pin circled in yellow would be discolored?

I have an unusual problem. A few nights ago, my polaris was running and the flex tube disconnected while I was asleep and probably shot out a thousand gallons of water right at my pool control box. One one hand the water shooting at it made the pump eventually short out in the box and turn off...

I was able to fix a few different solder point and all works well now. Thank you!

Hello, I recently purchased a new salt cell because I thought that mine was going bad due to the low salt readings on my aqua plus system. It was reading high amps and low salt of 1900, and the pool store told me I had a 3700ppm, which is close to what I had a week ago when it was working...

I have owned one since August. It works great at lower speeds but once you turn it up to 4 or clean it will give me an over current error and shut down. I have tried to call customer service but have never been able to talk to anyone. If I had to do it over again I would go with something...

I have two small fountains and a Polaris, but it has a booster pump.

It's not compatible, you would just have to keep the "filter" button on all the time and control the pump with the controller/timer that is located on the pump. I would like a pump that has to be controlled by the aqua logic only so I would not have to worry about something shorting out on the...

I was looking at that, but the 1.5 HP scared me off of it. Do you think it will be powerful enough for my pool? I pulled out the pool drawings and put in exact measurements of the pool and it is only 29,000 gallons. Thanks for all the help

After reviewing the costs of all, I think I'm leaning toward the Pureline brand at INYO pools. Any thoughts on the Pureline brand? Also, they suggested I go with a 2.7 VS instead of the 1.65 VS. I know they are trying to sell pumps so I was curious as to why they said 2.7 instead of the 1.65?

It says, Main Software Revision 2.86 and Display Software Revision 3.12, so I'm guessing I'm good to go? So I guess I need to weigh the cost difference between a two speed motor and a Hayward VS.

Hey all, My pump has gotten to the point where it is obnoxiously loud and I wouldn't be surprised to have the police knock on the door to talk to me about a noise complaint from any one of the 25 neighbors in my neighborhood. I have a 1.65 SF Pentair Whisperflo WF-4 currently. I want to...

Alright, sounds easy enough. I'll run by and pick one up tomorrow from Lowe's. Thank you so much! Sent from my SM-N910V using Tapatalk

I just bought my house in February and I'm slowly trying to get everything right, the pool looks great thanks to all the advice on here and a home warranty that replaced my control panel and display to my aqua plus. The last thing is the light! It had one of those Hayward Color Logic lights in...

Anyone? Any troubleshooting help??? Sent from my SM-N910V using Tapatalk

About 2 weeks ago we had our pool opened professionally. It looked amazing but when they opened it they discovered nothing worked. Sweet! That's why we got the home warranty...two weeks later the same problem still exists (local display saying communicatiom error) but I did gain a new...