Search results

After installing my VS Pump I left for a week to visit family, I go home today, went out to check everything out and the Aquarite Board shows a "PCP" on the screen and all the lights are on.... I had some issues off and on during the season with the board giving me a "too Cold" reading which...

I recently installed the "Hayward SP2303VSP MaxFlo VS" and I'm noticing that I see air accumulating at the top of the strainer cover. It goes away at higher speeds but returns at lower speeds. My old pump was not variable speed so I didn't see air in cover after about a minute of starting...

I just today added a Hayward max flow IS2393VSP2 on my SWG pool. I have the directions on how to program the timers but I don't have the knowledge on what times and at what speeds for the pump to run. Should it run 24/7 and at times a very low speed? Or 12 hours with various speeds- these...

I just ordered this to replace an aging and deteriorating sta-rite pump- I looked at reviews and they seemed pretty reliable and highly recommended. Does anyone have any experience with one of these?

I just ordered a new pump as my old one had a uncorrectible issue my question is: if I have to re-do some of the plumbing, does lowes or my local hardware store have the correct connections? I'm thinking more along the lines of the threaded connections that attach to the filter/pump

Hope this is in right area.. I'm looking for suggestions on a good quality 40+ ft vacuum hose. Mine keep breaking down at the skimmer and pinches together. I picked up a decent one at wallmart that seems to be rigid enough but it's only 30 feet and I need at least a 40ft one.

My pump motor has been sounding pretty bad for a while, I got some advice and I have its replacement on hand as well as a new pump seal and I am bout to tackle the job (watched a few you tubes regarding replacing seal!) Here is my questions(s) before I start: 1) would a motor going out greatly...

I'm pretty sure the bearing are about gone in my pump motor horribly loud and flow is quite diminished. I've seen what Looks like the exact configuration on Amazon for about $500+\- this would allow my to replace with Little or no re-plumbing Any recommendations ?

Hello I'm a newby from South Louisiana (Erath) 2nd season with my SWG pool- (came with house) had to buy new cell last season and now having Problems with control box Hoping to get advice from all y'all pro's!!

I have a hayward SWG, a day or two ago the display bgean to say "cold" when i clicked the diagnostics button it showed the water temp at about 76 degrees Today I looked at it and it says cold again and the temp shows anywhere from 45-49 degrees Actual pool temp is 75-77 degree's I called...