Search results

When installing a ABS Pentair push/pull valve to a PVC fitting, what glue should I be using? My plan was to use the Oatey red all-purpose glue on both fittings, and primer the PVC side only. Would this work fine?

Just did my first test using the Taylor K2006 kit. 9000 gallon pool FC = 13.8 ppm CC = 0 PH = 7.6 TA = 140 ppm CH = 370 ppm CYA off charts - about 1/2 way before it hits the 100 mark Looks like I'm all over the place. TA way to high, and I dont even know what to do about the CYA. Water looks...

Photo taken below at full RPM. The flap does not open all the way up (maybe half way - if that). Are these suppose to swing wide open?

First and foremost, there's a ton of info on this site and I'm glad I found it. Thanks in advance! I'm looking to replace my single-speed 220V electric guzzler with a 2-speed unit. I was initially looking at variable speed, but don't think I need it for my case. The pool setup is pretty basic...