Search results

Ever since August of last year, the pool is requiring an excessive amount of salt. I have about a 10,000 gallon pool. I can get the saltwater level up to about 2.9 and then over time it falls requiring me to go out and buy a new bag every month and dump it in. I have tried pouring it into the...

On Saturday, I cleaned out my Pentair filter and replaced some of the old screens. When I unscrew the inline Jandy SWG, DTE flows back into the pool from the filter. I assume its DTE because it makes the water cloudy. If I run the pool pump for about an hour, the water becomes clear again. When...

Back in February, my SWG produced an error code of 170. After troubleshooting using a meter to measure current, it appeared to be a front board issue. I replaced the front board with what I thought was a good board and I am still getting a 170 error message. I am not sure about the new board...

I have the Aquapure 1400 and the front board went out. I cannot seem to find it anywhere but, ebay where they are charging close to 500 for a used front board. So, based on my research, I have found a new Apure M for close to 500 which is a new unit with a warranty. My preference is to replace...

On Monday, the Jandy started beeping and produced an error code of 170. None of the front controls work when pressed so, there is no way to turn the unit off unless I pull the power. I tested the voltage coming from the transformer to the back board and the voltage is correct. I tested 1-8 and...