Search results

i have winterized pool and put cover on and everything is ready for winter except my heater. what are the procedures for this any help appreciated

i need to figure out some way to cover pool for the winter. i have a deck built all around the pool . there is no way to get a regular agp cover between pool and deck. would like to get an inground safety cover and attach it to deck but cant afford it right now. what are my other choices thx.

i live in lexington ,ky our winters can be mild to pretty bad, it fluctuates from yr to yr . first yr with new pool i have a deck all the way around pool what are the problems if i do not use a cover this yr i will clean shock disconect and do everything else just no cover pros and cons please

my nat gas cost me $5.134 per mcf to break that down into thermal units divide by 10.23 that gives me a price of $.50 a therm. so to heat my pool 13,500 gallons 10 degrees with 3.5mph wind and a 250k btu heater at 80% efficiancy should run me aprox. $6.25 is this right

thinking about buying this off craigslist ad it is foam and fiberglass. i have deck all around my ag pool . question is how would be the best way to hook this up to existing pool pump or run a seperate pump just for waterfall ? i have a 2 speed 2hp pool pump now

i will be putting a safety cover on my pool this winter it is a 15x30 abg. i have a wooden deck built all the way around it that is above the rails. so it would be attached to the deck. my ? is solid , mesh, brands tolook at brands to avoid and best place to buy online also i suppose a 15x30...

is there any problem to be concerned about if i keep the water level high say above skimmer i like a deeper water level but do not want to damage anything pump ,filter etc

I have been having to lower the water level 2 or three times in the past week or so due to storms. and the kids using the slide that is hooked to the water hose no hard task but I was thinking if I drilled a small hole in the rear of the skimmer where I would like the water level to stay would...

can someone please explain to me how to wire an intermatic timer to my pool pump i currently have a 2 speed pump that i run on low 90% of the time just looking to put a timer on it so i dont have to manually turn it on and off. the pump now currently plugs in to a gfci plug.

they finished pool last week and are working on deck. i had them run deck on top of rails so kids could not stand on them . also if you want to set on edge of deck and hang eet in pool you can. my problem is this makes the steps too short to attach to top of deck i will need to set the steps on...

the installers will have to dig down appr 3 foot on one side of pool. so i will be going down 3 foot tapering out to nothing on the sides. i plan on backfilling about 8-12 inches up on pool and tapering back the slope so there will be no drop offs to collapse and then putting down a tarp or...

i already have a 110volt 20 amp outdoor plug located 5-7 feey from where the pump and filter will be setting so i can just plug it. this plug is located right beside where electric service is going into my garage. there is a grounding rod in the ground with a copper wire connected to it for the...

i do have to provide a pad for filter and pump to set on. guy at pool store said to get some paver stone what are your guys thoughts on this stone airconditioner pad or what ?

aurora pools in lexington ky will be installing our new 15x30x54 wilbur quest pool may 13th i purchased the pool and install for 7000k this includes alum pool/ 9 inch resin top rails/ 25 mil designer liner ,2hp 2speed pump, 400lb sand filter,grand entry steps, electric aoutomatic cleaner, solar...