Search results

An old problem has come back again. No Flow with the Jandy Aquapure Handheld and the LCD panel one green light on and no error codes which I used to get in the past. The sensor is only about a year and a half old. The Chlorine cell is about 4 years old. I cleaned the cell (some build up but...

After 5+ years we were just told by the pool store that we have too much calcium in the water. This is a pebbletech finish cement (gunite?) pool. They said to take about a third of the water out and put in fresh. The water is crystal clear, and about 80 degrees. Since we are in Florida...

I show power going to the motor from Blue wire and the ground so I'm assuming the motor is the issue but it spins freely, and doesn't show any signs of burn or shorting etc. Is there a way to bench test it to make sure that is the issue? the cheapest I can find the assembly is $387 so before I...

I've got a Jandy Aqualink system with a Jandy Propane heater. I'm getting an error code on the heater panel of ignition fault, check ignition. Where do I start with trouble shooting? I took the front panel off and set it to run no fan no sound of an ignition attempt after about 5-10...

I have a Jandy Aqua Link system that is about 6 years old. This week the temp in the pool strated reading 177. It really is about 65. Is this a problem with the sensor (looks like it is held into the plumbing pipe from the pump with a clamp) or is there somethig wrong with the Jandy system...

I have a 5 year old in-ground pebble tech pool with a spa LED light and pool LED light (both were 120 volt). THe equipment is Jandy (handheld & electronics, pump and filter) except for the skimmer and LED lights which are Hayward. The pool light died and after much discussion with local pool...

I have a Jandy Aque Link v3.0 and every now and then it just quits working. the pda say "waiting" but won"t connect. I've turned off power at the breaker for a few minutes (even tried overnight once) and nothing. If I take out the screws that hold the top control panel in place and manipulate...

I have a Jandy Aqua Pure system and am getting a High Salt General fault on the handheld. The salt is reading 4800 but two pool stores get 3300. I replaced the sensor (for the third time in 5 years) and the new one has the daughter board. The service light is on in the outside panel error...