Search results

Hi All, I saw the message (System Manual Off) for the first time on my Aqua Logic Display. I'm not sure what caused that to come up on the display, but I was then unable to turn the pump on. I had to reset the configurations and then I was able to turn the pump on. But then I didn't realize...

While testing the AC voltage at the relays that are powered by the Aqua Logic Circuit Board, I inadvertently touched the leads and caused a short circuit on my 4th relay (1st relay is for pump, 2nd is for lights, 3rd and 4th aren't connected to anything). The 4th relay now constantly receives...

I've bene spending time learning the technical side of the pool equipment. I had a question about the transformer and the two rectifiers. Based on the pictures below, the transformer has two output wires (K - Both Yellow) (to get 24 VAC), but 4 input wires of 120 VAC (H - Gray, Violet, White and...

I have 2 Aqua Logic Displays with my pool system. One is outside next to filter, chlorinator and heater. The other is inside the house (same as outside except it doesn't have a service button). They are both connected to GLX-PCB-MAIN Circuit Board. Few days ago, the buttons on the outside...

I've read that self cleaning and reverse polarity are the same thing. When I go to Diagnostic Menu on my AquaLogic board, sometimes I see positive voltage and amps and an hour later I'll see negative voltage and negative amps. So does that mean my cell has the self cleaning feature as it...

I was told that I need to inspect and clean my cell with 20% muriatic acid and 80% water solution after every 500 hours of use. And that my salt system will have a inspect cell warning light pop up. My pump runs 24/7 from April to October. So this way, I hit 500 hours just after 20 days. So...

I have four relays with my Aqua Logic Salt system (Left to right - Pump, Lights, Aux 1 and Aux 2). I was trying to check how much voltage they receive and if it is AC or DC If I check for AC current, the Pump relay gets about 42 AC, and AUX 2 gets about 38 AC. If I check DC, then they're...

I have AQUA Logic Display and a Hayward Goldline Aqua Logic Main Circuit Board GLX-PCB-MAIN It controls two actuators which turn on the fountain jets and are connected to Aux 1 and Aux 2 of the display. (Aux 1 and Aux 2 also control the relays, but nothing is connected to those relays). The...

Hi All, My SWG started showing less salt, so I added more salt and it turns out I ended up putting in too much salt. So I removed water a foot at a time, until I got 3400ppm of salt. The Aqua Logic board is still showing very low salt, even though that's not the case. I did the following to...