Search results

Hi all, I need to replace the collar on the salt cell generator. I purchased the collar but not a replacement connector. Circupool says to cut the connector and reping to a new connector. I was hoping I can depin it by using an automotive depin tool. Anybody done this before? any idea what...

Hi all, I have a SJ-55 Chlorinator. today I noticed it was leaking from the back of the SWG. on closer look the blue plastic collar that holds the generator on and the wires go to the SWG was cracked. Any idea where to get a replacement?

Hi all I had a de4820 and dururing an unexpected frost the base cracked. New units are unavailable but I found a 6020 used. Brought it home and the upper pipe that connects to the bulkhead is broken. What wrench can I use to remove it. Also I have a 1.5hp motor. Should I use the 6020 or swap...

Hi all, I have a compupool cpsg16 I purchased in 2013. been a good system, but lately it's acting up. I get a low salt fault, even though I have 3300 PPM of salt. 3500 is stoic. So I calibrated the system, and went from 11 to 50. That got the sensor to turn off the low salt light, most of the...

Hi all, I just bought a zodiac mx6. Plugged it in and the flow valve collapses right away. Even fully adjusted. Any thoughts on this? Inground, salt, Hayward superpump 1.5 hp and Hayward de filter. 15000 gallons Thanks in advance

Hi all, I'm getting desperate. I have a Hayward SPX715x50 diverter. Last year I replaced the spider gasket on the diverter. It had served many years. The factory had put a blue adhesive on it. I have tried no adhesive, crazy glue, rubber cement, 3M weather stripping... it last for a few weeks...

Hi all, I'm having trouble with my Diverter. I put in a go kit and it is still leaking from the top. Is there any way to fix this? Looks like it's coming out of the recirculate stop hole, where the handle fits. Center post. It slows down when I put in DE.

Hi all, I'm getting desperate. Not sure if something crawled in and died or just full of twigs and leaves but I can't get enough suction to run the gear properly. I blew compressed air (150 PSI) with one of those bladders, saw some leaves come out on the skimmer side, but still had an issue...

Hi all, I had 0 for CYA last month so I purchased an 8 lbs stabilizer from leslies last month, and I had my water tested today, and I am back down to 0. Any idea where that stabilizer went? What am I doing wrong? Also any place cheaper to buy stabilizer? 15000 gal pool - Salt

Hi everyone. I have a 15000 gal salt water pool I'm having trouble with. I have a compupool 16 chlorinator. I just took apart the DE filter and cleaned it out. It had green slime all over it. Pool is a little green. After I cleaned it and added 6 lbs of DE it ran fine for a week. Then every...

Hi all, About a month before my 2 year warranty on my compupool chlorinator expired, the cell caught fire. I contacted compupool, and they said they would replace it. After several calls ( no parts in stock )I finally received a new cell and power cord. upon opening the power supply I noticed...

Hi all, I have a HayWard DE filter. that's giving me trouble. I just disassembled it and removed all the grids and all the grids and reloaded it with DE. Started off at 12 PSI this morning, and by the end of the day it was at 25 and the flow was so log my SWG was giving a no water error...