Search results

Hi Everyone. I have a Raypak heater that is not igniting when calling for heat. I can hear the spark, but no flame afterward. My best guess is the pilot orifice is dirty, or there is air stuck in the propane line. The worst part is the display is wrecked so I can't see if there are any error...

Hi Everyone! What would cause high filter pressure on a brand new FNS60? On startup the pressure shot up to 30psi and remained the same after adding the required amount of DE. EQUIPMENT SETUP Pump - Pentair Whisperflo 1.5hp Filter - Pentair FNS60 In-line chlorinator Heater - Mastertemp 250

I have a JXI 260P that fires up great but shuts down after a minute or so. Before shutting off and starting its cycle over again it makes a weird noise that appears to be coming off the header. Just recently there was a short in the sub panel, so I had to swap the PIB and transformer. After...

New member here. My Mastertemp 400 has no power when I hit the buttons on the pad. I checked the voltage, and I have 240 coming in (red pin 240 connected). I was hoping someone could explain how I could check the voltage on the transformer and circuit board, so I can determine what needs to...