Search results

2 lights need replaced. Trying to determine if they are 12V or 120V. I believe 12V based on this box where the lights are powered from. Haven't been able to get the cover off due to nearly stripped screws. This box is where the relay would be to reduce to 12V? Any pics of what I may see inside...

Jandy remote will only connect if within 1 foot of the antenna. Antenna failing? Frequency change due? Thoughts? Within the last year it has changed from working anywhere to having to be right next to the antenna. Thanks.

Just bought a Dolphin S200. The Polaris P280 just doesn't function well unless the water temperature is pretty warm. When folks change to robot, do they just abandon the old Polaris pump? Cut it out and cap off the piping? I'm thinking of trying to sell the pump as it works very well and is in...

Moved from HERE Sorry to dredge up an old (relatively) post. My water temperature sensor seems to have failed. Getting no reading on the Jandy PDA handheld. The control panel is an Aqualink RS. The air temperature sensor appears to be working fine. Last night, I turned on the spa but since...

About 3 weeks ago I switched to spa mode for my daughter and some friends. A short time later I noticed that the level in spa had dropped almost 1 foot. I had to keep switching back to pool mode allowing the spa to fill up through the single discharge to spa, then return to spa mode and turn the...

I just replaced the backup valve due to it spraying all the time. Found it to have a crack in it. Now with new valve the pressure relief valve is moving a ton of water. AND, the polaris runs to the deep end and stays there. Seems I have too much discharge pressure from my pump. Prior to...

We have an SGS Breeze 540. Bought the house 2 years ago. Already had an SGS 540. It was corroded pretty bad so I ordered an exact replacement cell 18 months ago. It cannot seem to generate enough Cl. Today results were 1.5 ppm Cl with sample taken right next to a return jet. Yesterday sample...

I am looking for quality, reliable grills for a new outdoor kitchen. Can you please provide some recommendations for grills you have at your homes? Looking online I've found several websites that claim to have the "10 best outdoor kitchen grills". However, looking at further websites I read...

Jandy 2.0 HP motor (R0445104 model) bearing making lot of whine noise. I replaced the seal this weekend after having the pump down for the last few weeks. Pump had run dry and gotten very hot. I replaced o-ring on suction pipe and lid gasket on pump at the same time as the mechanical seal. It...

Does anyone know how to get the CSI to log so I can track it? When I enter new logs it is not an option. I have to open the CSI "tab" and enter some additional data to see what the value is, but it never gives me an option to log it. I have selected to track CSI in the settings, but not borates...

Hello all, Our Jandy LXi 400 heater will not start due to the temperature being "high". The heater thinks the water temperature is 106°F, when it is really around 87°F. When I pull either of the temperature sensor wires from the control board, the temperature reading goes to -42°F and says...

Moved into new home last summer with pool. This is our 2nd salt-water pool. Have been using local chain pool store to test my water. Like I've read on here, we've been getting varying results from the high school help. Spending more money than we should have as well. We live in Houston TX so we...