Search results

I have a 406 a. It has died by virtue of rusting out in the bottom. There have been a lot of posts about these water heaters. Nonetheless, we got eight years out of it so I guess that is pretty good. I’m now needing to look into a new pool heater. There is a 407a and a 408a. The 408 is a...

I have a reproducible problem with my RS8 keypad about which I was hoping someone could offer advice. I have a Rev QQ Pool/Spa RS controller with the RS onetouch keypad. It has been functioning fine, and continues to work well -- until now. When I turn on the pool pump, the RS8 onetouch becomes...

I need a new pump for my pool. It is a 32k gallon pool with a Jandy RS Aqualink Rev QQ with Pool/Spa combo with 2" piping, Jandy membrane 420 filter and separate Polaris 280 with pump. The water fills and overflows the spa in its circulation; no solar or other attachments. There is currently an...

I have a 30k plaster pool with a Jandy RS-8, JVA, SWG, booster pump Polaris. Current setup is pool/spa, single motor, single speed. The pump is making noise and in fact doesn't power the spa very well. My pool guy has suggested a continuously running variable speed pump would be a good idea as...

I purchased a couple of WaterColors LED lights to go with my RS-8. Somewhere I read that there is a setting in the RS-8 that allows one to directly select the color or scene vs having to switch the light off and on in succession. Anyone have any info on that? Not actually sure which light I...

I have a ~30k gallon pool and a Teledyne Laars Series 2 250k BTU heater. My pool guy has said the Laars is probably running at 60% efficiency and so is just underpowered for the pool, and is old to boot. It has worked OK in the past but now seems slower than ever. The heater takes forever if at...

Wanted everyone to know about this new-ish device, the "Pool Control" by Autelis. I have a Jandy RS-8 OneTouch and had been trying forever to figure out how to get control from the house and also my home automation system. The pool is located 150 ft away from the house, and to run a 4 conductor...

I have a Jandy RS8 which works very well, and also has an AquaPalm attached, as my pool house is 200 ft from the main house. I'd like to have the OneTouch panel, currently in the pool house, moved to the main house for programming convenience. However, as a recent lightening strike in my area...

Had a failure of my Jandy PDA mother board for my pool. It has Pure Link Standard Power Center with salt water chlorinator, a couple of relays for valves, pump (single pump operating both pool and spa), breaker panel and heater control. I have a home warranty (AHS; have read about them on the...