Search results

I live near up north so I think insulation is a must for me. Just trying to figure out a solution that isn't "permanent" in case I have to repair something in the future. It was a NIGHTMARE digging out the hard foam surrounding the nuts on the jet body. Don't want to have to do that again if I...

Just replaced all the jets on my 2013 jetsetter and now I want to replace the insulation that I had to rip off. I still have the old foam but most of it is in smaller pieces so it would be a little difficult to reuse. I want to avoid using spray on foam (except for the bottom of the tub that I...

Gotcha. Thank you. Gonna try the loctite one and see if that helps. Also could I get your thoughts on which liquid leak seal you would reccomend that I use to circulate in the spa just in case I missed any other invisible or pinhole leaks? There is no other visible leaking but I just want to...

In your opinion which do you think works better? Loctite or JBWeld? Also is there any prep I need to preform on the outside surface before applying it? Sanding, cleaning, etc.? As for the front should I try to push/hammer in the crack so that it's flush with the shell before applying the epoxy...

Are you sure the water weld won't erode away with all the harsh chemicals? Also here is a better picture of the damage.

I looked up pool putty but a lot of the reviews mentioned that it was only a temp fix as the chemicals in the spa would wash it away over the years. Maybe Plastaid?

I have a 2013 Jetsetter and while dremeling out one of the old jets, the cutoff disk must have slightly touched the shell and now there is a very small less than a 1/4 inch crack in the shell by the jet. What is the best method to patch this up? Here is a video of the leak.

Ok so I bought myself a skimmer. Can anyone link me to a video tutorial of how to remove the old skimmer and install the new one? I have tried looking around youtube but I could not find anything.

Thank you for the reply. I just wanted to make sure there were no other options before I went out and bought a skimmer. Also do you have any idea what could have caused this?

Ok so I have not even had this pool for a year, ordered it summer of 2014 and I just took the cover off my pool to notice that the skinmer is cracked. I know I closed my pool correctly last winter and lowered the water level to the reccomended amount but now I have a question, should I order a...

No sadly I don't have a heater. Sorry about that. When I have time I will update my sig with the spec. Also, thank you for the information, since there is a high chance of snow still dropping I will probably have to wait a while before I open.

I live in the suburbs of Illinois and currently we just had some of the best weather that I have seen around this time (70-60 degrees). Thanks to the weather I was able to drain all the melted snow and ice off my pool cover. I took a look inside the pool to make sure everything was looking good...