Search results

Yes,.. that’s what he did!

I did place the pump on recirculate, no go. How would I know if air was getting in? I don’t see bubbles in the cell, how else would I know? It is a new pump, and filter

My husband loves me!

Note to self, do NOT glue directly to any piece I can’t replace in a hurry😡 I don’t think there is any way to get this flow switch out and then re-install it.

I’m confused, if I mount it vertically, with the flow going down, even with the pump off, gravity should keep the switch on shouldn’t it?

You guys have no idea how much I appreciate your help!! I have a birthday party at my house tomorrow😡I’m trying one last time to get this to work with what I have, before I send it all back. I have read several times about some concerns with the turbulence on my 90° angle possibly causing my...

One more try,..is there any reason why I can’t put my flow switch after my cell?

Mine is in a box/lean to

Ok,.. I’m done,.. I have now replaced every part, re-plumbed and moved my flow switch 8” from my pump, water is 72 degrees,. Turn on the SWG, it started briefly, then the flow light and the water temp light turned red, and the green generator light went off. Tried the hot salt water, nothing. I...

Thank you! I have limited space horizontally, so I am going to replace the spot where my flow switch is with as much 2” pvc as will fit, then a 90* elbow a few inches of 2” pvc, then place the flow switch vertically, then the cell. I am concerned about the connection to the cell, as I glued it...

Does it matter that yours has the square part (where the connections to the control panel are) facing up?

Ok all,. Pool hit 72 degrees today, SWG still not working. I’m going to cut my pipe and install the new housing for the flow switch tomorrow. I’m going to move it as far away from my pump as I have room for. One more question, does the orientation of the flow switch matter as long as the flow...

Thank you @eville! So, is the water temp light supposed to be on green when it is running? Even when I got mine running for the 5 hours, the water temp light is off. There also seems to be some confusion on where the water temp sensor even is. One guy told me in the flow switch and another said...

So, hot water did nothing, lightly salted hot water did nothing, heavily salted hot water turned it on. Guess that means that my pool water needs to be 105, salinity 20,000 for this thing to work😡😡😡

If I poor hot water without salt, won't the salt light come on because I have diluted the salt too much? You are correct, the low water temp light has never been on. The flow light has always been green. I will try plain hot water and see what happens. The DPS guy said that these were "picky"...

OMG!! I’m beyond frustrated! 😡😡 So, I received the new flow switch, and purchased and assembled a new shed so I have more room. Before I started cutting pipes, I called DSP again to verify how far away from my pump the flow switch must be and how high my risers should raise the cell above my...

They said to replace the flow switch because they think I have a bad temp sensor. I was hoping the sensor was the metal part inside next to the flow switch, I tried replacing just that piece, didn’t work 😡I’m off the the hardware store in the morning.

Ok my smart friends. I received a replacement flow switch. I messed up and glued the old one, so replacement will be a pain. Does anyone know where the temperature sensor is located? Is it behind the square that says flow? Or on the actual switch that screws in?