2020 Hayward Max Flo XL 3/4 : not able to disassemble the turbine

Jump to latest Follow Reply
L

Liooo80

New member
Sep 7, 2023
2
France
Hello !

My pump (installed in 2020, recent) is making a little noise (not permanent). It's a model with variable speed. I tried to open it by removing the four main screws, but I haven't been able to pull the impeller from the pump Strainer Housing. It's just open with 3-4 mm. BTW, it has been efficient, because the noise has disappeared. I think that a debris was the cause of the noise...
Do someone know how to pull out this impeller in case of need (it's blocked, i didn't want to pull strong) ?
 

Attachments

  • pompe-de-filtration-hayward-max-flo-xl-vitesse-variable-vstd.jpg
    pompe-de-filtration-hayward-max-flo-xl-vitesse-variable-vstd.jpg
    28.5 KB · Views: 1
There are 4 screws (#13) that hold the motor on to the back plate (#12) and 4 screws (#6) that hold the back plate on to the housing (#4). You want to make sure your are removing the later, not the former.


176189_0_202292610220.jpg
=
 
Thks for your reply. Actually that's exactly what I did by removing the four screws (#6) : But the back plate is only moving of 3-4 mm, even with lifting a little bit the motor while pulling. I tried to gently insert a screwdriver but don't want to break the back plate...
 
You must log in or register to reply here.
Thread Status
Hello , This thread has been inactive for over 60 days. New postings here are unlikely to be seen or responded to by other members. For better visibility, consider Starting A New Thread.
Top Bottom
Back
Jump to latest Follow Reply