I did but I'm not sure what happened to him...here one day, gone the next.Do you also have a Tweety Bird?
I did but I'm not sure what happened to him...here one day, gone the next.Do you also have a Tweety Bird?
The new pumps are VSF and they can show GPM, Watts and PSI.@JamesW, can a Pentair VS pump do that?
Yah, I misspoke. Watts show up in my EasyTouch, too. I've only once fooled with my pump display, when I had my EasyTouch board mailed out for an upgrade, so I don't know much about it, to be honest. The display doesn't even work anymore. I think I have the known problem with that (something about the connections underneath it). ET does all the programming. My stuff is not that old, but from the screenshots here, especially the IntelliCenter, I'm feelin' all stone-agie.
That is correct. I don't have anywhere to see pressure from Intellicenter.I don't think that the IntelliCenter shows the system pressure?
The PV3 manual shows a pressure gauge on the water valve but the PB didn't install one. There is a pressure gauge on the filter. Is it redundant to have it on the water valve or should I have it in both places?
Did the gauge ever get installed?I was running my IFCS at like 3000 rpm which was over 80 gpm.
I will definitely NOT remember that, lol!It's probably overkill, but if you're hitting 80 then you should follow Pentair's installation instructions. Otherwise, you might compromise the SWG, but more importantly its warranty. Things of this nature tend to get forgotten over time, and when your IFCS needs a bit more oomph someday, and you turn the RPMs back up, are you going to remember you can't do that (if you don't alter the plumbing). Your plumbing should accommodate all likely use cases, including future ones, and it sounds to me like it's not quite up to that.
The gauge was installed...it's only at 10-12 psi when at 2700rpm.Did the gauge ever get installed?
I doubt that you need 80 GPM.
I would dial it down as much as possible as long as it still works ok.
The manual says 20 psi, but that seems high to me.
I suspect that it would work at lower pressure.
View attachment 434680
Is the performance acceptable at that pressure?The gauge was installed...it's only at 10-12 psi when at 2700rpm.