For some reason my OmniLogic will not register pool temp. It worked last season. I have air and water sensors plugged in. The air works fine. The water is not. I swapped them on the OmniLogic and it proved it’s not the wired sensors because the OmniLogic then showed the air temp as the water temp. The Omni still showed pool as - - F. I’ve done code updlgrade. Rebooted. Even plugged in a brand new wired temp sensor. Nothing works. Could the two small holes on the OmniLogic where I plug in Sens1 pool be the problem?
Hayward OmniLogic not registering water temperature
- Thread starter Astewart127
- Start date
Omnilogic will only display temperature if the flow sensor detects flow. So your issue may be with the flow sensor.
BMerrill
Gold Supporter
- Mar 8, 2021
- 360
- Pool Size
- 17860
- Surface
- Fiberglass
- Chlorine
- Salt Water Generator
- SWG Type
- Hayward Turbo Cell (T-CELL-5)
It appears from the display that the filter pump is not running. No flow; no temperature.