We have a built in spa. It is relatively small so we heat it on demand. It is roughly 80" square, and we are looking for solutions of a cover to keep out debris. The main pool has an electric cover, but the spa is completely separate. We had a typical large foam cover but it was very difficult to move around and the weight caused issues with our coping getting cracked. (Probably was a little too small and barely touched the coping on each side causing strain) I saw a beautiful cedar roll up cover but the price was out of the range of what I am looking for. Any thoughts?
Built in Spa - cover
- Thread starter Hedgie
- Start date
- Jul 21, 2013
- 55,445
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
Post some pictures of your spa and existing cover so we can understand your situation better.
Here is the spa. We threw the old cover away, but it was a typical insulated spa cover that folded in the middle. As we don't need insulation I was hoping for somthing simple that would blend in well.
If you could include your location in on left side
<--------
it would be easier to answer based on your climate. Thanks.
Maddie
<--------
it would be easier to answer based on your climate. Thanks.
Maddie
- Jul 21, 2013
- 55,445
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
I think all spa covers end up being thick, heavy and ugly.
Try a "solar" cover. It should prevent evaporation and reduce heat loss.
Try a "solar" cover. It should prevent evaporation and reduce heat loss.