Recent content by zam

Had a similar issue last year and now again. These systems are poor quality and the screen stays on 24/7 when the pump has power. Last year I opened the system and cleaned out an ant farm. Attached cables etc, this year opened and cleaned lightly. Screen displayed yesterday not back to ON but...

Did you try these?

Looks like a Jandy, and the LEDs go out without much use. There is a new generation out now. Doubt that they are any better. Check and see if you still have the tool to remove with your pool supplies. It’s like a half circle

How are these doing? Similar issue here, one of my lights did last 4 seasons. What about the new Gen 2s from Jandy?

So what was the outcome here. Same issue, one of two lights flickering and then off. Is it the light, wiring, or transformer. Moved from here.

My salinity is ok and I replaced the cell which is chlorinating fine but also collecting air. The check valve right before has no air. Pics attached

12.5 gallons not a large pool

Thanks

I have strips, and I will have to check but I doubt its the salt level. Has more to do with air being in the cell. First year or 2 there wasn't much air in the cell, this year not only did I add the heater and bypass which has slowed down the GPM but the TruClear lid is leaking where the clear...

I have the third valve open, its a bypass for a heater.

Moved from here. I would like to add that I am having a similar issue with mine after I plumbed a heater. Water in the TruClear is right around the top of the fins. I was also seeing a small amount of bubbles coming out of the returns and yesterday my cell died. Not sure if it was due to the...

I have a similar issue with Truclear, ph is 7.2 cya is 40 but chlorine is pretty much non existent, did free and CC and both were between .5 and 1. 1 or 2 drops in test. I need to slam to 12 it seems but I don’t get the next steps? 12 for how long? Wait a couple hours see if it’s lower and...

So the Jandy valves use positive pressure, as in the water pressure pushes the flapper inside into the opening and helps with the seal. Did the install yesterday and then realized I have them both pointing with water flow into the heater, so I was like I have to turn it around when I have a...