Recent content by Zaffor

  1. Z

    Pentair INTELLICENTER App Ramblings

    So I finally got all my equipment wired up how I like it, and figured I would take a crack at the setup and programming. Thanks for all the amazing info from @MyAZPool which I read through before I even began. NOW... I am sure I am not the only one to realize these Pentair apps leave much to...
  2. Z

    IntelliCenter Circuits / Pump and Valve Associations

    Just stumbled across this Great post!! Thanks Ron!!
  3. Z

    Our First Pool

    i should have explained what all that was I have 2 low voltage junction boxes ran in series all with 1” pvc conduit. First box has salt cell - heater com - and 2 valves (heater bypass and return valve) Second box shown in last photo has 2 pump com cables (first 2 pairs) 4 intellivalves (intake...
  4. Z

    Our First Pool

    Cut the ends of my intellivalves and soldered them to ends of my wire runs Made most of my terminations and everything seems to be working fine i extended the temp sensor, the intellivalves, and spliced the pump communication wires. I wasnt sure these would work but @MyAZPool said he did it and...
  5. Z

    Our First Pool

    Got through some of my low-voltage / communication wiring today. Most of my runs were too long and needed to be spliced, so I purchased terminal blocks which just barely fit in my low voltage junction boxes and will splice everything on these blocks (two of them). I was able to run everything...
  6. Z

    Another The Woodlands, TX Build - Finishing up - landscaping and electrical

    Why use Load on FLTR relay to then feed another relay to run SCG and intelliph? seems like a waste of a relay?
  7. Z

    Our First Pool

    South Florida - New In-ground Large Build here is his build. You can see the wiring of his 2 panels with loads of transformers!! Also big props to MYAZPOOL who was and continues to be VERY VERY helpful. A wonderful member of this community. im sure there is a way to link to his user ID butI...
  8. Z

    Our First Pool

    GOOD EYE!! That last breaker is the 2hp spa blower. The load side powers the blower and the line feeds the relay and continues to the intellicenter just as you saw it. I wanted to use continuous feeds for the relays as it would eliminate anything coming loose and causing me to lose power to...
  9. Z

    Our First Pool

    Layout of the transformers. I left some room in case I want to install some fire bowls with automatic igniters in the future.
  10. Z

    Our First Pool

    A shot of the wiring inside the intellicenter i tried to keep the wiring as clean as possible and made up a jig to pre-bend the feeds to the relays.
  11. Z

    Our First Pool

  12. Z

    Our First Pool

    Night Time with just pool lights on. Have to photograph with features lit and post up.
  13. Z

    Our First Pool

    Thanks That pool in your sig looks pretty sharp too!!
  14. Z

    Our First Pool

    Trying to keep up with your shenanigans!! Still have much left but with a much better view. Thanks for all your continued assistance
  15. Z

    Our First Pool

    Daytime photo