Recent content by woneill

Sean thank you for all your help. I have resolved the issue, embarrassed to say I had the communication wire connected to the input post instead of comm bus & display.

Thanks Sean - I kind of figured it did but I couldn't find it anywhere so I had breaker off in case. I have corrected the wires as specified found the wiring config in section 4.3 of manual - must have been there the whole time :). Still have check system pool bridge comm error. But no longer...

PS just change out Filters and acid washed the SWG.

Thank you all for the help. I have now found the manual on line and connected as per diagram 4.3, although it doesnt show which wire goes from 2,3, and 4 on the controller to 1,7, and 8 on the ecostar. Hope it doesn't matter. I have two errors though, chlornator off low temp and check system...

Has anyone connected a hayward ecostar variable speed pump to prologic controller PS 8. I just installed the pump (plumbed and has power.) PS - 8 will turn it on. But need to wire it for controls so I can set the speed for the filter, pool sweep, and solar extend. No instruction came with...