Recent content by wishman

Hi, Looking to purchase the cyclone and trying to see how I can modify the lid for easy blowout. I noticed the intelliflo lid has a curve as well as supporting ridges underneath which makes the seem hard to drill keep flush for the locknut and gasket. Has anyone successfully modify the lid...

Do you have a pic of the skimmer and vacuum line? Could it be that you have a pin hole in the vacuum line where it's sucking in air?

@cowboycasey are you saying right after the heater but place the vertical kit horizontal or place it like the second pic within the tight gap? Thanks!

Hi, I'm thinking of converting to SWG. I have Jandy automation and Pentair VS Intelliflo pump. For easy DIY I'm looking at Circupoll RJ series. I have two possible location. The first being right after the heater but I would have to put the flo sensor before the cell. The second is a...

Thank you! I'll give them a call.

Do you remember where. you got it from? Conduitrepair.com has a min of 6 requirement. Also is it 1" conduit? Thx!

Hi, I found a split on my conduit. Looks like the previous owner tried to repair it by inject some type of caulking inside it. I was wonder if there's a bracket I can purchase specifically for this. I didn't see any on amazon. Can I use super duct tape? Thanks!

Pm replied

NJ is not that far, I could meet at a midpoint. :)

Bump - taking up space in garage. Make me an offer.

Hi, I been meaning to setup my stenner pump and tank system which I purchased as a barely used unit. Unfortunately never got around to it and didn't open the pool this year. Looking to sell it as we will probably go with salt system after renovation next year. This is 120v unit. Looking to...