Recent content by Wicked

Still no luck on the sync. It's weird because I assume these LED have no moving motor/parts. Unsure what to do at this point...

update: I ended up reading this manual about the connector to the main board. i used the button on the tri-sensor adapter to "calibrate: the flow for the unit per instructions: "On the tri-sensor adapter, press and hold the calibration button for five seconds until the "Flow" indicator is...

I think using your TDH with your pumps factory chart you can get close: http://www.inyopools.com/HowToPage/how_ ... auges.aspx

Thanks for the info. I will check the connections on the board today. I think that's the only thing I haven't done yet. Is there anyway to test/confirm the sensor is bad? Seems 1-1.5 years is not that old. I hate jus throwing parts/money at a problem without really confirming the parts are...

Hi everyone. Last season I installed a new Aqua pure SWG 1400 in my pool (full setup in signature below). Recently I have been having an intermittent problem that continues to become more frequent/permanent. This system has been working great for about 1-1.5 years with truly no issues until...

Thanks I will try this tomorrow and report back.

I installed an identical pair of jandy LED pool lights that run off the same circuit/switch. I just set it to a color sequence and the colors are off sync by about 1/2 a second or more. Any idea on how to get these lights to reset or re-sync? Thanks

as he said above - just connect things normal and it should recognize them. My pump is switched on by the RS

Great information. I agree with you that the results seem fairly linear comparing temp increase @ 60% with 90%

Thanks! Good info ill get an old sock ease into bringing it up.

Perfect - thanks. Looks like I may just need to increase CYA a bit. Ill search around for the best procedure to do that. Here is a pic from today [attachment=0:dfjjgbj5]ImageUploadedByTapatalk1365967497.788315.jpg[/attachment:dfjjgbj5]

Hey guys/gals. Just getting the pool opened up and here are some results - any thoughts? Things look good? My only questions are: the CYA a little low? my Cal a little high? what FC level do you recommend? (tested with TF-100) FC 3 CC 0 pH 7.5 TA 75 Cal 330 CYA 30-35 Temp 71...

excellent information! I will test next time I have the heater on and report back!