Recent content by wc!

As an update to this, I did not disconnect the bond wire from the panel this weekend. I did, however, open the panel and confirm that the bonding wire is in fact connected to the neutral bar. I also confirmed with the PB that this was not the norm in his builds (normally uses a different...

I measured it at the pool, from the water to concrete pad. That's what I was thinking as well (after a lot of research). I'll ask my electrician first to make sure he's not doing something wonky inside the sub panel, but I'll open it up and remove the bonding wire this weekend. I'll post...

It's really just a best guess based on my limited knowledge. When I back tracked from my pool sub panel to the main house panel and ultimately flipped the main on/off breaker to the house, I still saw the voltage. My understanding is that when you turn this main breaker off, the neutral is...

The SWG control unit was not bonded. There's a bonding lug on the bottom, but nothing was connected to it. I ran another #8 wire from that bonding lug back to the original bonding wire so that it's now bonded, but I still saw the voltage. It needed to be done per the manual, regardless. I...

Thanks for the responses! I know that the wire was connected to the rebar by what appeared to be a copper screw clamp of some kind. The rebar was plain exposed metal and was twist tied together at the over lapping points with some sort of wire. Unfortunately, I also know that the bonding...

This is my first post here on TFP, so I apologize if this is in the wrong place. We just had an in-ground pool installed and we've been swimming in it for about 3 weeks now. It's an 18x36, vinyl lined over vermiculite, polymer walled, salt water pool with a SWG, LED lights, a heat pump, and...