Recent content by waverun12

I have been running ours 24/7 for a few weeks SFX 1000 got to swap it out for my hayward skimmer /main - Intex 2500pump / and full time little intex 530 pump I ran that little secondary pump 530 gph which i figure circulates water all time especially when 2500 is off I ran it 24/7 for 7...

Well Gonna try a third one 14 x 42inch Summer Waves Elite again Should arrive tomorrow I bought a liner pad from home depot https://www.homedepot.com/p/Pre-Cut-Liner-Pad-for-15-ft-Round-Above-Ground-Pool-GP15R/206183892 I hope that will be a great add on as I said before its going on a flat...

can you put a metal wall pool on concrete slab?

drained out now and dry

Yea on the second pool the first leak is right above the seam in the bottom corner about 1/8 inch above the seam but still below the seam flap I am not sure how you would patch that successfully how do you patch over the whole seam?

yep returned the first one probably have to return the second one Polygroup just want to send you some patches wow!! Gee Thanks on a brand new (no make that 2 new) pools out of the box might be time to forget the pool for this summer

I have 2 of these pools so far last 2 weeks Both have leaked Second one has 2 leaks Whats the deal with the quality? Not sure if I want to try a third

true

How d that work?

Summer Waves

I always wondered if I was gonna Cut a completely new skimmer hole or 2 inch round hole, If you should/could take a couple pieces of repair patching ( larger than the opening you were gonna cut), and glue them to inside of pool and outside of pool?? Would that re enforce that area? Has any one...

Kinda along these lines I was nervous too but it worked out great We did mine when the water level was a bit below existing Summer Waves Skimmer round hole The Hayward fits perfectly over the opening you can cut the inside corners or leave them I always wondered if I was gonna Cut a...

Summer waves are good too