Recent content by wakerider017

Mine is still making chlorine despite the 121 code and low amps in reverse. 5ppm total chlorine today on only 30ppm CYA. Going to see how long this will go.

No significant amount of scale. Plates look good to me. Don't really see anything going on with the cord or prongs. I did add dielectric grease to the cord connector/ cell prongs in hopes that would prevent any outside corrosion and make my cell last longer.. Probably a nice thought, but at...

Well I think my PLC1400 (just shy of 5 years old) is finally on its last leg... Showing error code 121 (low current in reverse direction to cell). A physical inspection of the inside of the cell does not reveal much... Very minor scaling if any and no damage that stands out... 3,300ppm salt in...

I passed my OCLT this morning! Woohoo! Have my pump running 9AM-6PM and cell at 70%. Hoping to have FC PPM fall to 5-6 and be able to be maintained now.. Fingers crossed! @JamesW here are my voltage numbers while testing under load. Just over 29V. And here is the cell reversing...

Also I think I am getting close to the end of my SLAM. CL usage dropped off like a rock like Tue/Wed this week. Went from consuming a few gallons to a few quarts to a few pints in a day. All in I've used about 23 gallons of liquid chlorine so far. OCLT this morning showed FC dropped 2.0ppm...

@JamesW 5.6amps and 5.4volts (disconnected cell to measure volts).

double post

I have been turning off the cell at night so I could do the OCLT, otherwise it has been at 90%. I guess I can flip it on now since I know I will still have loss come tomorrow morning... I don't have a clamp meter, but do have a decent multimeter. So I could try getting an inline reading of...