Recent content by tkrunche

I test with the Taylor kit recommended on here. Thanks for the info!

Anyone have any thoughts on this? Can I get started on the salt addition while I wait for my CYA to arrive?

Thank you! I have read and saved that link. I have a couple follow up questions. I will not have the cya for about a week, but I have the salt and bleach right now. I won’t add the bleach until I have the cya, but is there any reason I can’t start dissolving the salt? Will that throw off the...

Hello! New liner is installed and the pool will finish filling today (hose water). I just took a sample today and it is updated on pool math. But to save a click I have: 0 chlorine, 7.5 pH, TA 300, CH 450, CYA 0, Salt 0 Temp is still quite chilly and probably won’t start heating for a couple...

Following because I have the exact same scenario. Have about 12” more to go before I turn off the hose. I’m in MN so it’s too cold to start heating (well, for my budget anyway). Is there an order I add stuff? I was thinking I’d start with the salt, then cya, then chlorine.

Yes just now, via a test strip....are those accurate (enough)?

The water table isn't higher than our pool (no water when they dug down and installed it). I'd rather avoid draining the pool. That'd be even more expensive than bleach I think.

Ammonia 0.25mg/L

Yes, I knew the stabilizer addition was a mistake, I must not have made it clear for my dad to not do that. What can I use instead of liquid chlorine? I can't find any and I know there is CYA in dichlor.

The saga continues. I've been pouring in gallon after gallon of liquid chlorine, enough to get to 10, and 15 min later it's gone. Then I had my dad working on it since I was gone again and he poured in a bit of CYA....probably up to about 40ppm. We can't find liquid chlorine anywhere (thanks...

Thank you! When you say "get a reading", do you mean it needs to read close to 10ppm or how high is considered a reading?

Ok, sorry I'm not responding quick. I have a kid in the hospital so I haven't had time to get to the pool consistently. I'm home tonight so I tested the water for the first time since my last post and I got <0.5 FC (I did 10 ml sample so it was just the tiniest bit pink, and probably wouldn't...

Ok, so was able to come home for a bit. Checked and there was 0.5 CC (still no FC or CYA). I added 3 gallons of 10% bleach which should have brought me to a bit above 10ppm. Waited 15 min and then it was 0.5 FC and 0.5 CC. So I must have that bacteria you speak of? Should I do the slam? Do...

Nope. I can do that today.

Hi-- I opened the pool just fine. Crystal clear, still had a bit of chlorine in from the winter. Six days ago my numbers were: FC: 3.5 CC: 0 pH: 8.0 TA: 225 CH: 550 CYA: 60 I added some Muriatic Acid (first time tried this brand, Jasco Green Muriatic Acid from Lowes) to bring the pH down. I...