Recent content by thomasjwhalen

I have both pumps, all lights and heater on the new GFCI breakers and all good so far. Planning to put the panel on its own 15 amp when I get the new transformer. Thank you for your help

The lights are 120v in the load center going to separate transformer boxes. Probably dropping down to 12v, I'll have to verify. Thank you

My control panel transformer fried. I should have a new transformer tomorrow. I wired the pool pump and salt cell directly to the 1st breaker to keep things going. The salt cell was wired to the pump 2 (waterfall) relay load side. I will move to the pool pump relay when I install the...

The 3 lower single 20 amp breakers are pool lights, waterfall lights and the heater, all three trip when trying to turn on with GFCI breakers installed. The salt cell was wired into the water fall pump instead of the pool filter pump. The control panel transformer was wired into the pool lights...

As noted in the picture, I put the single 20amp standard breakers back in and left turned off for now.

I have a breaker sub panel behind an outdoor kitchen that comes from the house main breaker panel. The sub panel had a double 60Amp GFCI that feeds a Pentair Load Center in the pool pump room. The double 60 GFCI would trip every couple of weeks then now daily. My plan was to place a normal...