Recent content by Texonfire

would you guys advise me to purchase this? http://dallas.craigslist.org/ndf/for/4018753575.html

Anything else I should consider before calling a repair company?

all I hear is an audible "click"

Here are pics of what I have

Let me take some pictures and post. I'm honestly not sure what I have. I do my schedule and operations from the Jandy remote.

It's not the timer I don't think. I can put the panel in service mode to manually fire the pump and it still doesn't work. I can post pics tomorrow of my setup. Thanks

I went out yesterday to a dead calm pool. :( My pump & cleaner were ON but no water was moving. So I checked and sure enough all was quiet. My pump just isn't running at all. No noises etc. When I try to turn it on at the panel I just hear a click in the panel, no noise at all from the...

Thank you Jason. That's the conclusion I came too after seeing the CYA chart, just wanted to double check. The skin on my hands is stinging a bit just from working in the water a bit earlier.

Hello, I have an in ground pool with a SWG. We haven't used our spa or pool all winter. We were wanting to use the spa so I decided to test the water. The FC came back at 14 which shocked me, I'm assuming I'm running my SWG at too high of a %. Also tested my CYA at 20. My question is...

Impeller was indeed badly clogged. Once I got it cleared and fired it back up water was flowing good again. Thanks for the help everyone!

I have not cleaned the filter but the pressure was ~10psi just 24 hours ago. 10 psi is my "clean" pressure so I think my filter is fine.

I back washed my filter 2 days ago, but haven't disassembled and cleaned it since May. My pressure has been great all Summer so I didn't see any need to do that yet. I haven't yet checked the impeller, but will do that when I get home.

I'm nearing the end of my first season as a pool owner. Haven't had a single issue all summer, until today. I came home today to find all kinds of junk in the pool from the trees surrounding the area. In a matter of 24 hours my skimmer basket and pump basket was full of this junk from the...

I finally got my new flow sensor installed after ordering the adapter cable etc... I installed it and it made my "General Fault" errors go away on my Jandy handheld. A couple days had gone by since I had installed and and hadn't had a chance to test my water until last night. I tested it and...

My water is crystal blue and a new flow sensor is on its way... thanks for everyone's help