Recent content by TexasYellowJacket

Using Florida Sunseeker PoolTone light board, I would need this transformer to convert to 12V?

2 lights need replaced. Trying to determine if they are 12V or 120V. I believe 12V based on this box where the lights are powered from. Haven't been able to get the cover off due to nearly stripped screws. This box is where the relay would be to reduce to 12V? Any pics of what I may see inside...

Antenna soldered. Connects once within 6 inches of antenna.

Remote shows great signal and full battery. I changed frequencies 3 times and none of them work. Have to hold the remote within inches of the antenna for it to connect.

Brand new battery did not help.

Jandy remote will only connect if within 1 foot of the antenna. Antenna failing? Frequency change due? Thoughts? Within the last year it has changed from working anywhere to having to be right next to the antenna. Thanks.

Any update on this? Mine is doing same thing. Won't pass the self-test in the water. Take it out of the water, upside down, will run and run with clear skipping of one track.

Just bought a Dolphin S200. The Polaris P280 just doesn't function well unless the water temperature is pretty warm. When folks change to robot, do they just abandon the old Polaris pump? Cut it out and cap off the piping? I'm thinking of trying to sell the pump as it works very well and is in...

All, No pics coming. I plead the 5th. I swapped the wires in the panel...only to find the air sensor wire is only like 3' long. That kills the idea of swapping them in the field. But, with them swapped, the pump will run. My handheld now shows water temp of 72°F (actual air temp) and air temp...

I will swap in panel and in field. I'm an idiot for not taking a pic when I had it open. I'll open it again tomorrow and take a pic. Any thoughts on issues with a non-reading air sensor? Wondering if I can run without it indefinitely.

Moved from HERE Sorry to dredge up an old (relatively) post. My water temperature sensor seems to have failed. Getting no reading on the Jandy PDA handheld. The control panel is an Aqualink RS. The air temperature sensor appears to be working fine. Last night, I turned on the spa but since...

Final resolution: Removed the check valve. The flapper looked good. The spring was strong (thus the reason it never appeared to open to me). I rinsed it off, relubed the o-ring, put it back together, and it is fixed. Obviously, some piece of debris was lodged keeping it slightly open at all times.

The line with the check valve in it must be the single line to the spa that causes the spillover. I never knew what that line was for. I assumed the spillover was just a branch off one of the main pool lines. To me, the check valve doesn't look like it is working at all. I tried to attach a...