Recent content by tcassutt

That makes sense, I will definitely check. Thank you for your help!

The return valve is set to spa and pool at the same time, about 3/4 of the way.

Thank you for your reply. I think the difference with the solar running is the higher rpm to get the water up to the roof vs when the solar is off it runs at a low rpm to just circulate. The low rpm is no longer enough to get the spa to go high enough to overflow, this is since the refill...

I needed to do a partial drain of my pool because of high CYA. I drained about 60% then refilled to where I believe the waterline was previously, a few inches up the tile. My spa is a little higher than my pool and has two waterfall overflows. The valve is set to send some water to the spa...

Hi, I am looking for a replacement for this waterways jet. I am seeing two numbers 215-1070 and 32MM 215-1087. When I look these up I can't find the same kind of jet with the threading in the back, and I am starting to wonder if this is 2 parts glued together? Any advice on a replacement jet...

We had an issue arise with our pool resurfacing and just wanted to check out if this is standard. We are having our pool resurfaced with a a pebble surface. The demolition went fine, but during the resurfacing something got stuck in the hose and they had to stop midway. They contacted us and...

Great. Thank you very much!

All right, thank you very much, I will try that. Should I also replace the nozzles as long as I have them off? Is there any benefit to new nozzles?