Recent content by taffmaster

Just for the water temp of the pool for my Pentair east touch panel

Not overly excited about drilling into the pvc pipe, but I realize it’s necessary. Does the sensor go in the inlet or the outlet pipe coming from the filter? Or does it go on one of the inlet outlet pipes coming from the heater?

Artificial turf not real turf. Hopefully no maintenance… guess I have a lot of work to do before Monday morning

I have searched quite a bit on here and can’t find anyone in my same situation. My decking is being poured Monday. We are doing the paver squares with artificial turf strips 6 inches between each pavers. Also 6 inches of turf all around the pool before the pavers start. The rebar in the squares...

Will I need to run the comm wire from vs pump to ET panel or does having it go through the relay give me all the control I will need to communicate to it?

Yes, I have the correct GFCI circuit breakers. I am using a zodiac, no salt generator. So I will basically never go direct to the breaker from the equipment, always go direct from equipment to relay. VS pump goes direct to line sides of relay so it will be hot wired. Heater can go direct to...

I hope this is the right place to post this question, I am new to the forum... I have been creeping around looking for the answer, but there seems to be a couple of different answers. My pool build is almost done, I am doing the electrical myself. I have Pentair Easytouch 8 control panel...