Recent content by Stevieso

Probably did not make myself clear. I want the spa heated to 102 and the pool heated to 82. I have set these temperatures on the Aqualink, no problem. I can't see how to do this on the heat pump controls. I have called Hayward three times. People there try to be helpful but I got...

Interesting ! I think you have put your finger on why I am not understanding the responses to my original question. The online link you refer to is dated 10/2009. (See bottom of title page). The printed manual that came yesterday with the new heater is dated Rev F 0616. I guess this means...

The heater has terminals inside the electronics box for the two 240 volt wires and the ground wire. Outside the electronics box to the right are two terminals for the 24 volt wires. The heat pump comes with a metal jumper connecting these two terminals. Reading the Hayward manual it talks...

What about the jumper on the terminal block ? Remove it or leave it ? How exactly do I "set to E" Thanks

Thanks guys for all your responses. I assumed the heat pump was faulty and the supplier has collected it and is shipping another one to arrive this coming mid-week so I will try your suggestions as soon as I have got it installed. The AquaLink worked ok before (setting the required pool and spa...

Thanks Jim for your response and your welcome. I can confirm that my old system with the existing Aqualink worked fine with just two wires from the Aqualink to the pump. Thanks also for the link which actually is the manual that I have supplied in paper form with the pump. I have read the...

New to this forum and desperate ! Just cannot understand the instructions for setting up that came with my new Hayward heat pump. The heat pump is a new Hayward HP50TA HeatPro. The controller is an old AquaLink RS4 (worked fine with my old heat pump). I connected up 240 volt wires to the two...