Recent content by Steve Bee

Where did you find replacement reagents on Ontario? I had to order mine from the US, through Amazon.ca.

So I finally got my resupply and topped up my CYA, raised the TA (tested 60 today?) and CH. My question, should I have waited til the FC drifted down before adding CYA? Was at 9.5 this afternoon. Haven't turned on SWG yet, but fired up the heater.

SWG off until SLAM complete and pump running on high.

No extreme changes in PH... I think the lines are around where the snow level came up around the pool.

Passed the OCLT with flying colors! Tested at 10pm, FC of 15 (added LC at 830pm, stirred) FC at 15 this morning with no CC. Should I do a final backwash tonight maybe? Pressure is maybe 10% over normal. Not the best pic (should've turned pump off), but it's clear! Yes, that is reading...

Waiting for more reagents, so can't afford a 25 ml test ;) Being in Canada sucks, takes forever to get Taylor stuff... and costly. I have been vacuuming with the same hose, do you mean vacuuming when FC is highest (a bit after dosing)?

A little hard to see because of my liner pattern, and not quite crystal water.

Maybe a bit cloudy still... but I think I passed OCLT. Was at 11 FC, added 1.3 Liters of LC. This morning's test was 17 FC.... still bit of CC though.

My concern is that they run the circumference of the pool, and it's more than 3 wrinkles in some places. It's like a 10 inch band of "slouch" around the pool, about halfway up. If it's fine to leave for the season, I'm happy to do that as I've spent a few days clearing it up and that would...

So as the swamp cleared, I noticed my liner has like 3 wrinkles that go around the entire pool? How does that get fixed?

Yeah, I am over slamming because I haven't had time to babysit, so overdosing to make sure I am covered. Looking almost fully clear today, will test this evening and hopefully get a backwash in tomorrow.