Recent content by SteakWit

I am so happy to find this thread. I had ordered the S1 Pro for $999.99. I then saw it "on sale" for $899 - when I was looking to see when it would ship. Since I did not receive it I emailed and asked for them to credit me the difference. They could not so I cancelled my order. A few days...

Amazon

Update. I went with the AquaPure PLC1400. So far so good. I started at 25% and then lowered it to 15%. I run the pool heater a lot so it was working too well. :)

This says it works with "AquaLink RS" (it does not say iAquaLink). Do you know?

Is this a DIY project? Thanks

Thanks for the quick reply. If I want to use my iAquaLink, the PLC1400 appears to be the most powerful option. That said, am I asking for trouble if it is rated for 40,000 and I have 30,000. Are there better options?

Hi. I have a 30,000 gallon pool. I want to switch to salt water. I have iAquaLink so I need to stick with Jandy for the SWG if I want it to be in my automation system. My choices are: (i) Jandy’s AquaPure (Model PLC1400; rated for up to 40,000 gallon pool); or (ii) Jandy’s TrueClear (Model...

I went with Loop Loc's Xtreme-aqua mesh. The all in cost for the Pool cover, the raised Spa cover, and installation (which requires new wall anchors for a new cable system) was $5,700. Thus, my third quote saved me over $4,000 (the second quote only saved me $800). My pool is a free-form...

I am still looking for a new Mesh Pool cover. Does anyone have a point of view as between Loop-Loc's "super dense" mesh vs their Loop-Loc's "aqua-xtreme" mesh? Thanks, Andy

I have my pool in a residential setting (my home :) ) and we use the heater a ton. It is constantly on in the spring and fall. We also open in March and close in December (in SE Pennsylvania), so the extra cost is a function of how YOU plan to use the heater. I just had a Pentair MasterTemp 400...

I am going to reach out for some more quotes. If anyone has a reputable vendor in SE Pennsylvania, let me know. I have a Merlin quote I just called Loop-loc. They are coming out on Wednesday. Any others to call? Also, if the Merlin Rep did the measurements should all Merlin dealers be the...

I have an older pool cover which is starting to show significant wear and cracks. It is a hard cover with black bungie cords. My pool is a free-form pool with one entire side raised, and a spa which waterfalls into the pool. The existing cover drapes up and over the side wall and over the spa...

I replaced the membrane pad and control panel and it now works. Interestingly, the membrane pad was disconnected. The installer must have set both pool and spa to 104 and then unplugged the pad since I use automation. Is that typical? I opted to not replace the High Limit Switch or Thermal...

@JamesW: Would you bother replacing the High Limit Switch and Thermal Regulator or would you just replace the membrane pad and control board? I now have all 4 parts in hand. Andy

No. Andy