Recent content by smerls

I am not sure if the whole air gage assembly moved, it is possible when I opened it the shoot assembly moved. I did try gently moving it back and it did not move. I just know the top piece that shows the pressure that turns to release air is now facing about a quarter turn or less from where it...

Thanks for the reply I do appreciate it. My issue with the guage is not where it is facing I don’t care either but that it moved position which I don’t recall ever happening before so I was a little concerned about that not where it was facing. That maybe it is not fully closing or something...

I have a Hayward cl200 in line chlorinator which I only use occasionally when I go away. In general the cap has been a pain to close and line up with the tab. Since I was back I went to put in the last two tabs that I had but no matter where I started from when putting the cap back on i could...

Sounds good I just wanted to check. Yes this is a good wake call for me to pay closer attention! Thank you!

I am closing my pool up and I was balancing off my chemicals. I was going to add a little more calcium which I should have just left alone but I instead I added cya directly to the pool because I was distracted. I have brushed most of it up. And don’t see much on the pool floor. Tomorrow I was...

Will do, I thought it might help but just wanted to check it see if it was a no -no. I actually bought some epoxy last year but never got around to doing . Thank you!

Sounds good thank you for the reply!

Hi, Sorry if this has been asked before. I have a plaster pool 28,000 gallons. One of my skimmers has about .5-1 inch crack at the very top where it joins the top piece and is 1-2 inches long. I don’t have a picture of it as I my pool is not open yet which I am going to open this weekend. I...

I thought I was overeacting which I often do but just thought I would double check..Thank you!

Hi All, I am not sure if this is the right place for this, my apologies if it is not. I am getting close to closing up my pool for the season and I noticed a couple of small spots in the expansion joints between the coping and the deck that needed to be redone. The decking needs to be re-done...

Thanks Crystal River! No heater and the trichlor feeder that is installed is after the filter and all the equipment and it is designed for the pucks but I still need to be very careful with the pucks as in the past just getting a good whiff of the chlorine when taking the top off is not...

Hi Bperry, I have not logged in for a bit, so I missed a few posts. Actually this was a problem, when my father was using the pucks, we often had to add backing soda to make sure the ph was high enough. The last year or two when I stopped using the pucks, it went the other way every know and...

Hi Texas Splash, Thank you for the welcome and the reply I do appreciate it and it does help!! Also hope you did not get hit too hard with the recent cold spell! I guess I was thinking that because the tabs continually feed chlorine that it might be a little different than liquid and more...

I have a couple questions regarding the use of Trichlor tabs using an in-line chlorinator. The questions are listed below if folks would like to skip the background, sorry if the background is a little long but I think I over thinking this instead of keeping it simple but I would like to...