Recent content by SlipperyPete

I didn't think about it when I installed it. Was at 307 no long after I fired it up. Maybe 3-4 minutes. My spa runs for an hour every morning. The heater warmed it quickly. When the pool was turned on after the spa, the heater warmed up the pool pretty fast as well. I set the pool pump to...

The new sensor came in late evening on Thursday. I installed it and the heater seems to be working. It ran fine for an hour until my pool schedule kicked in and turned off the pool. I’ll test for longer in the AM and report back.

The filter is about due for a cleaning, but it's usually not bad. I keep my water crystal clear thanks to this site. I can make time to clean it this weekend to be safe.

Interesting. I've had the same settings for 5 years. The heater errors out in spa mode as well when it is pumping at 55 GPM.

the app shows 30GPM & 1,979 RPM in pool mode. spa is 54 GPM & 3450RPM

I did. I posted it earlier, but I just referred to it as "my handheld". The heater cut off when the exhaust temp hit 309. I didn't get a picture b/c it cut off as I was getting my phone ready.

The air temp here is about 73 degrees. The flue didn't feel too hot. I was a little warm from trying to run the heater. I bought a sensor on Amazon. It will be here tomorrow. I'll swap it out tomorrow and see if that changes anything. I can't express how much I appreciate the help. :cheers:

I have no idea. What should I be looking for, the valves controlling the water flow? I have intellivalves, so I don't touch them. I will go check to make sure they are operating as they should. However, the heater errors out whether I'm using the pool or spa.