Recent content by shellbmb

Is the Globrite still being manufactured? I have had terrible luck with the Globrite and just replaced all of them with microbrites after they all failed. I guess we'll see how long they last.

Finally got around to replacing a failed intellibrite with a microbrite and pretty easy process with the niche adapter. But one issue. When my lights kick on, they are not synced. I manually sync them and they are fine until they go off again for the evening. I have them programmed to run...

Thank you sir. Yes, I have 4 on one relay (pool) and 1 on the other relay (spa). 2 of the 4 on the pool relay are not acting up so it must be the globrites then. Sigh. Well, at least i've already purchased the adapters to the microbrites as it doesn't sound like there any any more reliable...

In ground pool since 2014 and I've had my fair share of globrites go out on me so I'm used to how they behave. Lately I've had some that are acting like they are going out, then all of a sudden they are working again. Usually the seal will leak ,water will get inside and one of the LED's will...

Searched around and found several threads about Globrite failures and I've had my fair share. So looking to transition into Microbrites if possible. Has anyone had luck with the niche adapter by pentair? And if so, do you have to replace them all at the same time, or can I just replace each...

How did you change your globrite to microbrite? Did you have to break out the housing and re-plaster in a new one? I have 5 globrites and two are currently out. I've probably replaced 10 in the 8 years of pool ownership. Terrible design and product.

Ahh, gotcha. That makes sense now. Most of us pool owners in Texas still have some PTSD from the "snowpocalypse" a couple of years ago when we lost power for a week. Power went out in the middle of the night so I didn't get to drain the equipment fast enough. Mind you it was 7 degrees...

Thanks. Yes, I can find all that and all the circuits that should have freeze on do. I guess my question is how to I calibrate or adjust the temp probe when currently it's correct? I don't think it's going to be near 32 tonight so I won't be able to check it. I would assume I would need to...

Yes, I do. But the current temp displayed matches the current ambient temp of about 58.

Normally my freeze protection kicks on when the temp gets close to 35 degrees. We haven't had a freeze yet, but we've come close twice including last night. I noticed that the freeze protection wasn't kicking on and that my Pentair app was showing the ambient temp at 43 degrees when I knew it...

I assumed it was proprietary. Mine are the black ones about 5 inches long that you insert then turn 1/4 turn to lock. When I search the model number, different varieties come up. I normally search for part number 602055 as that is the 100' variety. But on Pentair's website, it shows a...

I've had to replace several of these. Shocker I know! These things have to be the most poorly designed pool light ever and Pentair should be embarrassed. And since the housing is embedded in the pool plaster, kind of hard to change. Never tried to use the old cord as a pull string. I've...

I'm using an Intermatic Model PX100. I opened up the J-box and confirmed all the connections were solid. Same issue. I have not tested the voltage. It's just odd the way that light is performing. I've had several Crud out on me and they behaved differently. But could just be a bad light.