Recent content by sharpie101

Outdoors. No screen.

Got it. And thanks for that PDA thread, its quite helpful.

Ok, turned off the cell at 9:30 pm last night and left the pump running all night. Tested the water at 10:10pm: TF-100 FC 8.5 CC 0 Test at 6:00 am: FC 8.5 CC 0 No chlorine loss overnight. I had also tested this earlier in the afternoon using the TF-100: TA = 50 CH = 250 CYA = 60 Do I...

Unfortunately we only have one night every 24hrs here in Florida and I was testing the cell. I can do an OCLT tonight and confirm tomorrow. Let's assume I do have chlorine loss with a CC reading of 0, what could be causing this? and will the SLAM procedure kill whatever is causing it?

generessler, thanks for chiming in. A few things that might have been not clear: 05/2011 - Pool built 08/2014 - Single speed pump died and is replaced with a Jandy VSP running at 3250 RPMs 09/2014 - Notice original PLC1400 cell stopped producing chlorine and new one was installed 09/2014 on -...

Late reply as I had to take the kids to their last day of school this morning. Tested at around 7am and here are the results: The cell appears to be producing chlorine. This was with the pump running at 1725 RPMs and under Pool Boost overnight, so now I have more questions: - As mentioned...

Ok. I spent quite a bit of time playing with this today and I am more informed. The VSP option is there and it was setup. I had it setup at 3250 for the pool and now I remember that I did not know how to accomplish what I wanted to do, which was to run the pump at low speed for 10 or so hours...

Pump runs from 9am until 5pm at 3250 rpms daily. I know low flow through the cell is a problem, would high flow be an issue as well? Or will the cell produce chlorine while the pump runs at high speed?

Done

I used the TF-100 … its up in the thread, I am thinking you missed that part? The size of the cell, 1400, is also stated both in the original post and my profile. Guessing you missed that as well. I mean, I am looking for help, but not sure you are looking to help or start an argument. I know...

Hi PoolGate, thanks for helping here! What image are you referring to? the last one is from WaterGuru, it measures a few parameters daily and it is not related to any of the Jandy stuff. I really do not think the cell is working based on all the chlorine I have been adding. When I first had...

I let it run for one day and FC went from 2.5 to 0. I then took a sample close to a return and checked with my TF100 and it read zero as well. I am sure the cell is not working even though it says otherwise. I will try and contact PoolGate Thanks!

This is where I noticed the dip switch settings, I only see an option for single speed and two speed pump. Not sure I should select the two speed pump or if I need to upgrade to a different board:

I had my system installed when the pool was built, all Jandy. Aqualink w/PDA controlling: - Single speed pump - SWG 1400 - a couple of valves for pool/spa - Heater A few years down the road my pump died on me, so I decided to purchase a Jandy JEP 2.0 epump ... this is when my troubles started...

Forgot to update. Took me almost a month but I got it back