Recent content by ShaneP

I’m looking to replace these old return jets. Has anyone had any dealings with these? They screw into the plaster with multiple Phillips head screws. I haven’t taken them off yet to see if they slip or screw into the PVC.

So I had him do a 50% water change and slammed the pool for 2 days until we met all criteria then vac to waist. OCLT was less than a ppm. I'm having him turn off the chlorinator today so his levels will go down enough to swim tomorrow. Thanks for all the advise. PS the ColorQ x2 numbers were...

Thanks for the suggestions. I do have the Taylor K-2006 complete(fast-DPD chlorine) tester but I’m currently low on R-0013. I usually test my own pool with both kits and they are fairly close. Tomorrow I will start working on the water exchange. It’s been very hot and little rain for the past...

Working on a buddies pool Fiberglass, 8500 gallon, Chlorine pool with sand filter, chiller & heater combo. He had it tested because it was a clear & green. his copper read 3.1 so the pool company gave him some liquid and an absorbent pad to put in his skimmer (Don't know what kind of chemical)...

Are you still satisfied? I just purchased one. I just pulled it out of the box. Do I have to do anything to it before I run it in pool?