Recent content by Seminole

Well with my unit i can set the temp i want the water to increase to under settings, normally it will start the heater and once water temp rises to set temp, it will keep the temp at what ever the setting is. Does this jive with your understanding?

So, this heater starts quickly when I use the manual heater mode. I set it to bypass operation to allow my pro logic to set the temp on my display and heater light illuminates (as normal), however, heater wont start. NOTE - this method did work just two weeks ago. I do not understand how this...

Ok so Since my last post. Pool is clear and seemingly stable. CYA - 80 FC - 11 CC - 0 TA - 80 Ph - 7.5 CH - 350 SO, I am looking for further advice to lower the FC. I've been running the SWG at 25% for 2 days now and the FC level is about unchanged note- my display shows the SWG (Chlorinator...

Yes, I would agree, just leaning on y'all a bit. I'll address the CYA as you suggested. OTO! Bright Yellow... Got it. It is right now, and I'll decrease the % some so to be closer to the FC 6. Thanks! Seminole

ok, another day in my saga. tested this am. CYA 60 FC 11 CC 0 I am going to assume my SWG is working now, it has been set to 65% for last 24 hours (pump time of 10 total). Two questions now... Am I correct in assuming the SWG is functioning correctly? Shall I add some CYA to raise the...

As for the CYA - 60, Iv'e tested with the TF-100, and just as the kit says, when the black dot disappears is at 60, of course I am a rookie at the determination of exactly when that occurs so it could be a little earlier raising the CYA to maybe 70 I'd guess. I am going to have to drain some...

OK good point. I'll leave it alone. Thoughts on setting on SWG?

SO it appears to me things are back to normal. Since last test results I've been running SWG at 100% 9 hours a day (2 days). Latest results...just now pH 7.8 FC 12 CC 0 TA 90 CYA 60 CH 320 (maybe I am still learning testing) Im going to drop SWG to 50% now and see where I end up at pump...

So, I have done this suggestion. 100% on the SWG. I waited about 20 minutes and sampled the water on the downstream union. The result of the test shows me a FC 6 (maybe 6.5). Any thoughts on where the FC level should be with the SWG at 100%? or how much higher it should test than pool water?

Ok so after my SLAM, and a few days of swimming, I have the pool balanced well (so I think). PH - 7.8 - I will be adding some acid shortly FC - 6 CC - 0.5 - yes, i know... CYA - 60 TA - 90 CH - 350 My pool looks great, and I am ready to turn on my SWG again after the SLAM and am looking for...

I'd say the CC is <.5. Pool is very clear. Noticeably. I'd say crystal.

This am I was still at FC 30. Unchanged through the night.

I find myself curiously looking forward to testing... today at intervals of approx 3.5 hours I am SLAMing my pool. 3 hrs. after last test I was at FC 23 added 2 more gallons 4 hrs later (just now) at FC 30, CC about 1 maybe slightly less This pool is as clear as I've ever experienced. The...

Update... SLAM has been initiated. FC 32 (TF 100 kit measured 2 hours after bleach delivered) CC 0

Ok Ph in check at 7.2 FC is now 0...