Recent content by Ryano2121

I have the Pentair 4 cartridge filter system with a Pentair VS pump. 25,000 gallon in ground pool, completely redone one year ago. (signature is wrong, we moved). My filter gets clogged up every 3-4 weeks. We have a small spillway that stops running water when the filters clog. I think it's...

I have a meter. With the 2 thermistor wires twisted together, where am I putting the second probe?

It's not protected, I can do that. But this one lasted one week. This makes me think something else is causing the big swings in resistance. Could it be the wire? I have a 2 story house so there is a long wire going to the roof which the thermistor is connected to.

Solar hasn't been working consistently. Solar temp in the ET was erratic going from a very low temp like 9* to a very hot temp like 255*. Switched the wires for the air and solar on the ET and the odd temperature followed to the solar thermistor, leading me to believe the issue is the...

I have a 2 story house so there is a long wire going from the ET to the roof.

Looks like I had a bad sensor then bought another bad one. Changed it out again and it appears to be right now. If it changes again I'm gonna replace the wire I guess.

Ok. Checked resistance. The new sensor is at 7, water sensor is at 9, air sensor is at 8.5.

Swapped the solar and air sensor wires. Solar was 256* F before swapping, then after swapping Air is 256* F. So its the board?

Lol, yes, I did double check that. All 3 temperatures shown are in Fahrenheit. I read quite a few posts where people found odd temperatures like I am. I erased the EEPROM today just to see if that wouod fix it. When I went to Calibration, the air and water temperatures were accurate, the solar...

I have an EasyTouch system. My solar wasn't turning on despite it being hot. I checked the solar temperature under Calibration and it was 25* F. It would only go up to 34*. I did some research and replaced the solar temperature sensor (Pentair 520272) today. After replacing, the temp was 4* off...

DC, not AC right? Which are the output leads going to the pcb?

It's an external power supply, not part of the EasyTouch. There are no lights on at all. Transformer is wired for 220, configured as you said, 220v between the two inputs. There is power to the transformer. Looks like I need a new board.

At the circuit board right? 0.04 VDC

Yeah, it steps down to low voltage. Hope I don't have to buy a new one!

I found my IC40 with no power today. It is connected to an EasyTouch and its own transformer, wired to come on with the pump. Diagnostics say No Comm. It is enabled in the EasyTouch with 35%. I checked the fuse on the transformer and its fine. There is 120v at each wire inside the transformer...