Recent content by rxman

Update: I tried the plastic method without any luck. But then I made some progress! I opened up my Paramount PV3 gear valve dome and plugged the port going to the spa. Voila. It did not drain anymore! Then I removed the plug just to see what would happen and it still did not drain. This is with...

I removed the jets and used a threaded plug to plug each of the jets. The spa still drains. :( Looking at the picture above, I have a few things left to try. The in-floor cleaning system and the light. Assuming the drain and return are ok via replaced Jandy valves and check valve. I used food...

Sorry. Actually it doesn't end up exactly at pool level. It's still above pool level when it stops. I do not have a valve to shut of the infloor system and it is the only return to the pool.

I really appreciate your help. It drains to pool level in both pool mode and spa mode. Has anything changed? Not that I can think of. In my testing last night I noticed that the air blower did not instantly produce air through the jets. I had to cycle the blower on and off many times until it...

Yes. It runs fine

I have received the parts and rebuilt both Jandy valves. Still draining.

I believe there may be a check valve on the floor cleaner but it’s buried underground. I semi attempted to dig it up but can try again. I thought if it was leaking through the cleaner then the level would be lower. Maybe not?

Jet Spa is closed. Pool Return is open.

That’s the first jandy valve pic. Pool return sends water through the floor cleaner which has a station in the spa.