I know this is an old subject, but.......
After having the error code 124 ( a bad circuit board ) for 4 different boards, I finally bought a Jandy 1400 salt cell and took out the Compupool salt cell. The system fired up and has been running perfectly for about month now.
Lesson learned; the...
I had a Jandy rep tell me today to unplug the salt cell and turn off the pool equip for 15 to 20 min. Reconnect the cell and power on the equipment.
This MAY remedy the problem. 3rd party cells don't usually work with Jandy. I did that and my problem still exists.
I think I am going with all...
The cell is completely clear. It is brand new and only used about 3 months. It has a clear outside. I can see it is clean. A test will show way too much chlorine. I have been away and the kid watching the pool used way too much shock. At this point, pics won't help. Right now, the cell...
This all started when my salt cell died. I replaced it and it worked for a few months it died again. That was replaced under warranty.
I have Jandy AquaPure with a new PIB (Power Interface Board) and a new J1400-3 CompuPool salt cell. This is my 3rd PIB and 3rd salt cell.
The error code says...
I am new to my own testing and this is a BIG learning curve.
I finally figured out Free Chlorine. Now I need a bit of help with the CYA.
When I test the water, my results does not come up to the 100 mark. I round that to 150. Is that correct?
The SWG is not working at all. I am waiting to get a new control board. I get an error code that says my ctrl brd is bad. For 18 years I have been within a reasonable margin with 2 of the local stores.