Recent content by RMJackson

I did read that online searching for causes, but when I look at my circuit it doesn't show an option to set a VS speed. I wish there was some instructions online.

I recently replaced my single speed WhisperFlo pump with a WhisperFlo VST. I wired it into the comp port and thought I had my EasyTouch set up correctly. The pump comes on and runs as intended normally and operates correctly under freezing temps. But when I switch to spa the pump goes to zero...

I believe it did get warped and that's why I'm replacing. I have rebuilt it previously when the seal began to leak. The output pipe is now leaking and is lose. I tried to reseal it thinking that was why it wouldn't pump, but no luck. I doubt it's worth saving.

It should be a Polaris 280. It's my pool vacuum.

Thanks for your recommendations. I have updated my signature with that additional information.

Pentair intelitouch panel

Hello everyone, I'm joining to hopefully get some helpful ideas on how to address a few aging issues with my pool. My pool is about 16 years old and some components are showing their age.

My switching valve went bad and sucked my spa dry running my pump dry for who knows how long. I replaced the limit switches and the valve working again, but it appears the pump ran dry too long and now won't pull strong enough to pull the water up to the pump. From what I am seeing my pump has...