Recent content by RichardU

I logged in solely to thank you for this post. I was looking at replacing five different fittings to get to a clear section of pipe. Cheers.

My GFI has one spa light and two pool lights. The spa and one pool light work fine. The second pool light trips the GFI whether there is a bulb in it or not. I have tested three different GFIs and they all act the same. The ground wire for the second pool light is connected to a bus that...

I just had the same problem ... saving anything caused lost connection. Fixed it with a wired ethernet line.

The motor on mine doesn't spin at all. If I disconnect the leads to the motor, I get a 24vac signal to them upon pool startup. However, when I connect the leads to the motor, I can't register any voltage when the pool starts up. I'm guessing the motor is shorted. Any other ideas? Thanks, Richard