Recent content by rhosch

I'll.... do some digging. I have cat6 from control panel to my network closet inside, so wireless isn't really a big deal to me.

Oh, well yeah I guess I muddied the waters there. I installed the link. Don't recall the cable I used. I believe it uses rs485 for the communication protocol but may just be two wires connected.

I wonder if there are settings on the pool/spa dual body ET4 that aren't available to me on my single body pool only ET4?

Well that's definitely an interesting approach I hadn't thought of. By low voltage, you mean one of the rs485 communication wires? And by extra relay, you mean in the easytouch? I need to take a close look at my ET4 again. I have pool lights, hardscape lights, and a valve that turns spills on...

Well, maybe there just isn't a way to do this then in the way I'd like. I had thought from Jimrahbe's response to this question a year ago that perhaps screenlogic exposed some additional flexibility. He posted this pic, and suggested different set point temps could be set for different times of...

Thanks, two good suggestions there to consider and play with. I knew I could shut the pump off, didn't think about turning flow rate down low enough. I can play with pump settings and see just how low that needs to be. Guessing too low to keep spills going, which we like to do into the evening...

Hey guys, taking another shot at this issue this spring. I'd like to program my system so that the heat pump only runs during the day, for increased efficiency. Pentair ultratemp, and easytouch 4. I do not have screenlogic. I'd rather not purchase it just for this purpose unless that's the...

m replacing the motor assembly in my prowler 920 after posting here and trouble shooting without luck. In researching I found threads asking about the difference between 920 and 930, non Bluetooth and Bluetooth enabled model. The motor assembly for 920 and 930 are the same. The control units...

I've thought about suction side cleaner but the way our pool is plumbed and setup that isn't ideal. We have an infinity edge and smaller catch pool. The skimmers on upper pool don't really do anything since the flow is all away from them and over the infinity edge. There is a single skimmer on...

Hmm... well I see the 9995388-EX assembly says it's for the prowler 920. They both look the same visually but this one is just $450. Being half the price of replacing the whole thing (and since the control box is already brand new) I guess that makes more sense.

Yeah, and I'm not seeing a replacement motor assembly (part 360365 for this model I think) for under $600. I hate that but spare parts looks like where this one is headed.

Well, big bummer. Replaced the impellar motor brushes, pretty easy job. But no dice. Behavior both on back and in water is identical as before. To eliminate any other variable I removed extension cord I was using and plugged directly to outlet. Same. The one thing I'm seeing that seems...

Oh, awesome, I'll give that a shot. Cheap so no harm done if it doesn't help. I guess I thought since the current brushes have to spring back a couple of mm for the motor to fit between they were still good. Here's hoping for a cheap win.

So... drive motor still most likely? Brushes don't look bad to me. Anyone think it's worth replacing them anyway, or have any other idea short of the whole $450 assembly?