Recent content by Reeeba1

Thanks. Just had a hurricane come through here and dealing with a lot of flooding in our community so I haven’t had any time to work on this, but I plan to do it this Thanks. We just had a hurricane barrel through and have a lot of flooding so I haven’t worked on this yet but will this week...

Thanks. That helps a lot. Now I know I do need to remove the automation part to do it manually. Do you know if I would turn it clockwise or counter? I don’t want to move it the wrong way. My assumption is counter based on the other valve for skimmer and main drain. We do have a multimeter but...

Thanks. Pool mode would be off to the left. I will get some better pictures. We’re having tropical weather and heavy rains down here so I was a bit hasty with my photos! Stand by.

Hi there. You all were able to help me once before so I’m hoping you can help again. I have a Pentair easy touch automation panel. We use a remote control to switch our pool from the swim out spa to the regular jets and back. The remote control reroutes everything based on a valve. When we used...

Thanks for all this. I’ll check it out.

Thank you. Bubbles do not decrease. I really wish I could figure it out!! Appreciate the help…

Yes - pressure gauge and valve both tight… thank you

Sure. I’ll get a picture. I actually did clean the filter and the pump basket. I bought a new gasket for the pump basket lid, replaced it and added silicone. Also removed and replaced the gasket on the filter which is less than a year old and put silicone there too. I just keep thinking that...

It’s a little hard to see inside the pump, but again when we first start it, it runs normally with only a little bit of air at the top and then as it runs some of the air bubbles start to bleed back in, which is what looks like is happening now. I didn’t seem to be able to post a video.

Here are some photos of the set up. Please don’t look at the leaves! Just blew out the gutters last week. ☹️