Recent content by Rduffy

I think the SWG is working again. I had to save the instant salt of 3000 and the system stays on now. I will keep an eye on it and post again if I see any issues. Thanks Everyone!!

The filter pressure is just below 20 and that is about what it runs with a newly cleaned filter.

I have a AquaPlus system. The interior Aqua Logic panel might be wrong because the interior panel was missing when we purchased the house. Contractor installed that one.

I will check the flow switch also. Thanks much!!

No the aquarite panel stays on with the pump turned off. I did notice a change the last time I went through the menu’s. In the diagnostic menu the instant salt 3000 + to save after hitting + the SWG is continuing to work instead of turning off after a minute or so.

I believe so.. Is there an easy way to be sure it powers off?

The reading in the diagnostic menu is 2900 ppm.

Hi members, I think my salt water generator is going out. I have the check system red light on. And the controller states the salt is at 2600ppm. Tha SWG is just short of 3 years old and is a Hayward T-15. I have cleaned it twice and again since it quit working. The drop salt test shows the...

Thank you TFP!! I started maintaining my pool last December with absolutely no experience. After going through the pool school and ordering the TF100 test kit and purchasing the suggested chemicals I was able to maintain the pool with absolutely no problems. I test the water weekly and with the...

No the pump runs at 60% 9-5 daily. I had the installer come out yesterday. On the Hayward pump there are a set of dip switches that need to be off. He checked and the were so he turned the power off for 2-3 minutes and the pump ran all day. Apparently if you don't leave the power off long...

I have a whole house surge protector at the meter provided by the power company. Since closing on the home in November we have had very little lightning or stormy weather.