Recent content by RCrew80

Long story short, when my heater was hooked up last fall the guy I had hook it up left the 120v plug in the circuit board…..when he wired everything up for 240v. Watched a video saying going thru install and the guy said to make sure and NOT do this otherwise you will kill the heater. Hoping to...

Reviving the thread as I got the pump turned on after winter. Put a new fuse in and it blew almost instantly. What/how can I check to see if it is in fact a bad board?

Correct plug is there now. Everything is 240v. Had to switch pump wiring to accommodate for the 240v also.

Don’t remember voltage…was checked after install back in September.

Just posted a picture. That fuse is blown. See pictures in other reply.

Not sure why it the plug was switched. Voltage is correct. Pump and heater are on same 240 breaker. I opened up to take pictures and noticed this fuse appears to be blown (circled in green).

You’ll hafta forgive my lack of knowledge…but I assume PCB is the circuit board?

Long story short, when my heater was hooked up last fall the guy I had hook it up left the 120v plug in the circuit board…..when he wired everything up for 240v. Watched a video saying going thru install and the guy said to make sure and NOT do this otherwise you will kill the heater. Hoping to...